On OrCAD Pspice, we will simulate 10 different circuits for DC-Sweep, AC-Sweep, Transient and Parametric-Sweep Analysis
What you will learn
What is SPICE Simulator and How it works?
Where do we use SPICE Simulators?
How to use Cadence OrCAD PSPICE Simulator?
What is DC-SWEEP Analysis and how to apply it on different complexity level circuits?
What is Transient analysis and how to apply it on different complexity level circuits?
What is Frequency Sweep or AC-Sweep? And how to apply it on different complexity level circuits?
What is Parametric Sweep? And how to apply it on different complexity level circuits?
Description
This course is divided into #5 different sections, under each section I have discussed different complexity levels of circuits and their SPICE simulations:
Section-1 In this section I have discussed
“What are SPICE, How it works, and Types of simulation we can do on Cadence PSPICE?”
Section-2 is all about Level-1 Circuits, their maths, and simulations.
“DC-Sweep, AC-Sweep/Frequency Response, Transient analysis on different RC and LC filters”
Section-3 is all about Level-2 Circuits, their maths, and simulations.
“We’ll start with circuit introductions and then perform frequency responses and bode plots for gain/phase margins, Circuits we’ll discuss under this sections are Active LPF, Inverting and Non-inverting Amplifiers”
Section-4 is all about Level-3 Circuits, their maths, and simulations.
“Under this section, we’ll start with Basics of Buck converters and do few derivations to do design calculations, then we’ll draw it’s schematic and perform different spice simulations like Frequency responses, Probe and understand the working, how we can make it better with a close loop buck converter, etc.
Section-5 is all about Level-4 Circuits, their maths, and simulations.
“Under this section, we’ll start with Basics of Boost converters and do few derivations to do design calculations, then we’ll draw it’s schematic and perform different spice simulations like Frequency responses, Probe and understand the working, how we can make it better with a close loop buck converter, etc.
Content